Building A Robust Crosscutting Jig For Circular Saw.

Need to set up a new jig? If a crosscutting jig is required for your circular jaw, the best place to begin would be using a video explaining all necessary details needed to push forward.

Creating this from raw materials will require a structured approach, but this video has enough quality to provide ample value. You’ll enjoy the value provided in this viewing, and that’s critical when looking to set up a new jig that will work well in all situations.

circular_saw_cross-cutting_jig-1

Image source: Log Lab

Continue to the Next Page  video to get started towards your goal of building a great crosscutting jig: SIMPLE Circular Saw Cross-Cutting Jig.

Next Page

12 thoughts on “Building A Robust Crosscutting Jig For Circular Saw.

  • December 15, 2016 at 9:43 am
    Permalink

    Great video! Clear instructions without unnecessary gabbing. I need to make a 4 ft. one for plywood sheets.

    Reply
    • December 19, 2016 at 7:13 am
      Permalink

      My first thought also – maybe hinge it on one side for ease of use

      Reply
      • December 27, 2016 at 12:48 am
        Permalink

        My first thought is that a hinge is a stupid idea

        Reply
  • December 21, 2016 at 5:02 pm
    Permalink

    Stellar for a first video! I like the idea of a 4′ one for plywood.

    Reply
  • December 26, 2016 at 1:41 am
    Permalink

    How about n 8’6″ one for cutting full sheets long wise.

    Reply
  • December 28, 2016 at 7:03 am
    Permalink

    Yes I always wear Flip Flops shoes when I use power tools NO Need for safety here

    Reply
  • December 28, 2016 at 12:56 pm
    Permalink

    I still carry the scar of a drill bit when I was working barefooted. Shower clogs are no protection when you are working with sharp or heavy tools.

    Reply
  • December 28, 2016 at 9:08 pm
    Permalink

    Very good video! A little more info would be good! But over all it is very clever!

    Reply
  • December 29, 2016 at 4:03 am
    Permalink

    At the beginning of her video she shows why that crosscut jig is unnecessary. Just use your speed square, and you get nice straight cuts every time. And you save time by not using that silly jib.

    Reply
  • December 29, 2016 at 1:30 pm
    Permalink

    if you own a framing square and are a bit handy with wood its not difficult to build one of these, but can we please have a user with a better choice of footwear??? flip flops,really?

    Reply
  • December 30, 2016 at 10:02 am
    Permalink

    Could put PTFE tape on the rails where the saw foot contacts the guide. Smoother travel.

    Reply

Leave a Reply

Your email address will not be published. Required fields are marked *